The Pool Wizard The Pool Wizard    About TPW    Contact TPW    Search    Home  
Beachcomber Hot Tubs Beachcomber
Hot Tubs


In Ground Pools

Vinyl Liners

Above Ground Pools

Did you know?

A low chemical sanitation system will help prolong equipment life.

Showering before entering a hot tub helps prolong time between drainings.


Fort Ethan Allen
Essex Jct, VT
802-655-5300
Below are the basic maintenance procedures for your Beachcomber Hot Tub. Following these guidleines will help keep your tub in good working order, and keep the water clean and sanitary. Beachcomber 730 model  
 
Beachcomber Hot Tub Maintenance Schedule   

Printable Version

Initial fill / Nature² replacement
Add 1 pint Eliminate according to lable directions.
     Filter water overnight, and rinse the filter cartidge as needed.
     Insert New Nature² unit.

Run system on high speed.
     Add 2 Tbsp Chlor Blast per 300 gal. water
     Let system run on high for additional 15 minutes. Leave cover open for a total of 30 minutes
     Add 2 capfuls Soft per 300 gal. water.
     Add 3.5 oz Pure Blue per 300 gal water.
Adjust pH, Alkalinity, and Calcium Hardness as needed.

After Each Use
Add 1 Tbsp Bromate per 300 gal. water
     Run system with cover open for 15-30 minutes.

Weekly Treatment
Run system on high speed.
     Add 1-2 Tbsp. Chlor Blast per 300 gal water.
     Add 2 oz Pure Blue per 500 gal water.

  The following day
     Add 3.5 oz Pure Enzyme per 300 gal water.
     Add 1 capful Soft per 300 gal water.
     Add 1 oz Eliminate Plus per 300 gal water.
Adjust pH, Alkalinity, and Calcium Hardness as needed.

Periodic Maintenance
Hot Tub should be drained and wiped down every 2 to 4 months depending on use. Days between draining =
Gallons of water ÷ 3 ÷ average daily bather load.

Filter cartridge should rinsed clean every 2 weeks ( or as needed ), and treated with Filter Pure at least once a month.

Nature² unit should be replaced every 4 months.

For cloudy water or odor, treat water with system running with 2-4 Tbsp. Chlor Blast per 300 gal water.
Allow filter to run until tub clears or odor is gone.
( additional doses of Chlor Blast may be needed, maintain a 3-8ppm level until tub is clean ).

During the warmer months, the cover should be taken apart and cleaned with Cover All and allowed to dry. This will help extend the life of the cover, and prevent musty odors.

Beachcomber Hot Tubs


|| Beachcomber || In Ground || Liners || Above Ground ||
|| About TPW || Contact TPW || Search || Home ||

Roman End Legacy Edition
^ Roman End ^

Shelter
^ Shelter ^

Portable Pools, Install in an hour